Caframo® Propellers and Shafts for Crossover Overhead Batch Mixer
With the blade welded to the shaft, this impeller is immediately ready to use with the 1540 Crossover (Cat. No. 430-98235) and start mixing. No tightening or adjusting set screws is needed, and the one piece impeller is desirable for sanitary applications. The three-blade square pitch propeller is 152 mm (6 in.) diameter, composed of 316L stainless steel. Blade is cast, then polished and buffed to a mirror surface finish type #4. The 13 mm (1/2 in.) diameter shaft is constructed of ground and polished 316 stainless steel for enhanced corrosion protection, 914 mm (36 in.) length. For pilot scale and small production volume mixing. Axial flow effective for low shear mixing.
Image(s) are representative of the product group and not necessarily the individual product.
Read More
Image(s) are representative of the product group and not necessarily the individual product.
With the blade welded to the shaft, this impeller is immediately ready to use with the 1540 Crossover (Cat. No. 430-98235) and start mixing. No tightening or adjusting set screws is needed, and the one piece impeller is desirable for sanitary applications. The three-blade square pitch propeller is 152 mm (6 in.) diameter, composed of 316L stainless steel. Blade is cast, then polished and buffed to a mirror surface finish type #4. The 13 mm (1/2 in.) diameter shaft is constructed of ground and polished 316 stainless steel for enhanced corrosion protection, 914 mm (36 in.) length. For pilot scale and small production volume mixing. Axial flow effective for low shear mixing.
Image(s) are representative of the product group and not necessarily the individual product.
Image(s) are representative of the product group and not necessarily the individual product.
Certificates of Analysis
This service is currently unavailable!